DC Electrifier Usage Instructions
The DC Electrifier has three main purposes for use ;
1) to kill cancer cells,
2) to accelerate the speed of wound healing,
3) to fight localized infections of bacteria, virus, or fungus
ELECTRODE PREPARATION & PLACEMENT
The alligator clips should bite the electrodes so that one of the jaws is between the two layers of cloth. The sides of the electrodes without an exposed jaw should be placed onto the skin of the patient. If the metal jaw is allowed to touch the skin then the skin will be damaged by the electricity. Remove the electrodes from the alligator clips after the treatment of the patient to lessen possibility of the clips metal corroding.
 
TREATING
CANCER
Studies have proven that tumors can be reduced or eliminated by application of a few milliamperes per square inch across the tumors. To have a strong immune system to fight the cancer cells it is recommended that only good habits are maintained by the patient. These include avoiding: alcohol, nicotine (from tobacco smoke), sugar (except for what occurs naturally in food), excessive animal protein consumption, and tap water (because of the fluoride and chlorine). It is necessary to sleep 8 hours every night, drink bottled spring water, take colostrum pills to boost immunity, expose your skin to sunlight, get exercise every day (to increase your blood oxygen), and eat fresh fruits (especially purple grapes) and fresh organic vegetables. ELECTRODE PREPARATION & PLACEMENT
The cloth electrodes (1.5" and 3.75" square) should be completely wet with tap water. If the skin above a tumor is raw and the current creates too much pain then place the electrodes on opposite sides of the sore.  For cancer treatment the electrodes should be placed on the skin so that the electrical current flowing between them is also going through the tumor. The small electrode should be the one that's closest to the tumor.  DEVICE CONTROLS
For cancer treatment the 3mA/5mA switch should have its lever towards "5mA" which allows up to 5 milliamps of current to be delivered, depending on the control knob position.
INDICATOR LIGHTS
The red light comes on fully when the amount of selected electrical current (a max of 3mA or 5mA) is flowing between the electrodes and through the patient. TREATMENT TIME
Apply 5mA current across the tumor for 4+1/2 hours every day for 10 - 20 days. Treatment time can be broken up into segments throughout the day. RISK REDUCTION
You can reduce your risk of damaging your skin with this high level of current by following the instructions posted here.
TREATING WOUNDS
Wound treatment for the first treatment is basically the same as cancer treatment in that the current needs to be 5mA and the location of the electrodes should be on both sides of the wound so that the current flows through the wound. Treatment time is around 23 minutes. The following 7 treatments need to be around .4mA which can be found by setting the auto/manual switch to "manual" and turning the dial sufficiently counter-clockwise so that the patient doesn't feel the electric current. These 7 treatments need to be for 3 hours each time and switch the electrodes every 30 minutes so that the polarity is switched.
BATTERY REPLACEMENT
The batteries are four 9 volt batteries. They can easily be replaced after removing the four box screws with a screwdriver. They need to be replaced after either you can no longer get the red light to fully come on or you cannot get any stinging sensation at a maximum dial setting. Alkaline batteries will last the longest.
|