Simple DC Electrifier Usage Instructions
TREATING
CANCER
ELECTRODE PREPARATION & PLACEMENT
Studies have proven that tumors can be
reduced or eliminated by application of a few milliamperes of electric
current per square inch
across the tumors. It is still important though to
strengthen your immune system to remove dead cancer cells and not allow a
recurrence of cancer later. It is recommended that only good habits
are maintained by the patient. These include avoiding: alcohol, nicotine (from
tobacco smoke), sugar (except for what occurs naturally in food),
excessive animal protein consumption, and tap water (because of the fluoride
and chlorine). It is necessary to sleep 8 hours every night, drink
bottled spring water, take colostrum pills to boost immunity, expose your skin to sunlight,
get exercise every day (to increase your blood oxygen), and eat fresh
fruits (especially purple grapes) and fresh organic vegetables.
The cloth electrodes
(2+1/8" and 5" square) should be completely wet with tap water.
Connect the red alligator clip to the exposed copper wire on the small
electrode, and the black alligator clip to the wire of the large
electrode. Place the electrodes on the skin with the non-metal side
touching the skin.
For cancer treatment the electrodes should be placed on the skin so that the electrical current flowing between them is also going through the tumor. The small electrode should be the one that's closest to the tumor.
If the skin above a tumor is raw and the current creates too much pain then place the electrodes on opposite sides of the sore. It's also important that the electrodes are kept pressed to the skin so that the electric current remains evenly distributed. Place some plastic from a shopping bag between the electrodes and your hands if you are using your hands to hold them in place. But since the treatment time for cancer is long it would be best to use a long elastic bandage to hold the electrodes in place.
DEVICE CONTROLS
For cancer treatment the automatic/manual switch should have its lever toward
"auto" to automatically have a regulated 10mA of current flowing
between the electrodes. If this is too painful then you can switch to
"manual" control and adjust the amount of electric current down
with the current adjust dial. But using current levels lower than 10mA
requires a longer treatment time.
INDICATOR LIGHT
The indicator light comes on fully
when 10mA of electrical current is flowing between the
electrodes and through the patient. Much less than that will not turn it
on. If it won't light up at 10mA when the unit is
new then it's possible that the patient is dehydrated and needs to drink much
spring water. If it won't come on (after many hours of use) then maybe the
batteries have low voltage and need to be replaced.
TREATMENT TIME
Apply 10mA current across
the tumor for 4+1/2 hours every day for 10 - 20 days. You
can break up the treatment time into segments throughout the day.
A main contributor to
the cause of cancer (besides toxins and radiation) is bacteria. The most
common source for bacteria in the body is dental infections. Dr. Dowling (www.breastcancercured.com)
found that almost always cancer patients have dental infections. He has
verified this over the last 30 years of cancer diagnosis. He does an
infrared scan on his patients to see the inflamed areas of the body that
point to where the bacterial infections are. Then he sends his patients to
a good dentist to clean out the infection if it's in the mouth. Bacteria cause a
suppression of the body's ability to fight cancer. A scientific study
(click here) in 1989 has proved the bacteria-
killing ability of electric current. You can use this unit to kill
bacteria any where in the body. Just place the electrodes on the body so
that the infected area is between the electrodes and the small electrode
is closest to the infection. Set the switch to "manual", turn
the dial to the 3 o'clock position, and keep it on for 20
minutes which is enough to kill the bacteria.